When the Note Latch option and the Volume Envelope module are both active, you will be able to trigger the loop by pressing a MIDI note defined within the sample's Key Range, and stop the playback immediately as soon as you press the same note again. Go back to the Main tab and make sure that the Volume Envelope module is active (power button is on) and that the AHDSR envelope curve has been selected.Go to the Setup tab and activate Note Latch.Go to the Editor tab and enable the Loop button, then click the Add Loop (+) button to define a loop range.Load a loop into an empty BATTERY Cell.This can be achieved using the Note Latch (Standard) method.įollow the instructions below to configure BATTERY 4 to control the playback of an audio loop: When working with long loops or samples it is sometimes useful to stop the playback of the loop with the same MIDI note. I guess it has something to do with the mounting procedure and wine accessing the *.iso image, but for now I am a bit stuck.BATTERY 4 Cells can be triggered using any available MIDI note. I also tried some other packages with the same result. "Disk not found: Please Insert Battery 4 Factory Library" the Battery 4 Library) I got an error during the installation: Mount -t udf '/home/>/.wine/drive_c/users/>/Downloads/Battery_4_Factory_Library.iso' -o unhide /mnt/cdrom0/įor some packages I was able to install the packages and everything was fine, but for others (e.g.
I googled a bit and found out it's possible to mount the image manually using e.g. For all packages I got the error message "Install failed: Error while mounting disk image" during the installation. Running Native Access is working fine and I was also able to install some packages (e.g. I was trying to install some software of the Native Instruments Suite via Wine 6.0.1 on my ubuntu 21.04 (but also tested 18.04 with the same result).
0 kommentar(er)
